Monday 5 December 2016

Painting an Arrowhead

I'm finding it harder and harder to keep up with my paint guides. Real life can be such a problem sometimes and it certainly doesn't seem to let up. Anyway here's how I painted my Arrowhead.







I started with a Grey primer which formed the base coat for the ship. Next, I carefully masked of the entire ship, only leaving the cockpit exposed. The bright blue cockpit is almost a trademark for the ships in R-type so it was important to get it right.

I started with a mix of VGC Imperial Blue and VMC Blue Fluo. For each subsequent layer I mixed in some VGC Magic Blue into the mix. When I had reached pretty much pure Magic Blue I started mixing in some VGC Turquoise. For the final layers I also added some VGAir Dead White.


I used Magic Blue for the blue details, VGC Sombre Grey for the grey parts, and VGC Scarlet Red for any cables. With that done I sealed the entire model with gloss varnish in preparation for the shading stage. I applied AP Dark Tone Ink directly to the recesses and when that had dried I sprayed a layer of satin varnish all over the model.




Highlighting was mainly done in three layers for each colour with the exception of the red cables which I only highlighted with VGC Bloody Red.
Fuselage
  1. 1:6 mix of VGC Stonewall Grey and AP Matt White
  2. Diluted Matt White
  3. Almost undiluted Matt White
Guns and exhausts
  1. 3:1 mix of Sombre Grey and VGC Wolf Grey
  2. 1:1 mix using the previous set of colours
  3. 1:3 mix using the first set of colours
Blue Details
  1. 3:1 mix of Magic Blue and Wolf Grey
  2. 1:2 mix using the previous set of colours
  3. Wolf Grey

I painted the engine glow by first applying several thin glazes of AP Blue Tone Ink. I then switched to Magic Blue to increase the intensity of the glow. For the later stages I also mixed in some Matt white and the closer to the middle I got the more white I used. The last layers was almost pure Matt White.


The Force Unit was painted pretty much the same as the rest of the ship with the notable exception of the orb. I originally went with VMC Orange Fluo for the orange colour but unfortunately I managed to scratch the surface which lead to a reset. After I had stripped the paint I instead went with the much easier to handle VGC Hot Orange.

No comments:

Post a Comment